Bought Buriantsu Bee*R limiter and installed it exactly how it is suppose to be installed

followed this guys write-up and know his worked cuz i have seen him slide CFRC with it plenty of tiimes

https://www.tamparacing.com/forums/ni...all-guide.html

With the Red REV set on 0 which = 2500 rpm and the gain at F which shoud make the car back fire pretty good it does nothing just goes stright thru the RPMs, the red light will come on at 2500 rpm but wont sit there and flash

if anyone has any clue why its being dumb lmk plz thanks

 

VIDEO0028.mp4 video by doloresend - Photobucket

 

Do you know for a fact it was working when you bought it? I have heard of these going bad

 

I think 0 is off. That pic robyou posted is confusing. Your sposta tap into the wires not cut them off from outputting into the outgoing harness wires which is what it looks like. Also, Do you have a test pipe? Also make sure you have the right loopt wire cut.

 

kid said it worked, yea i tied into the lines not just cut them. and its not on 0 i tried ever setting and it didnt work.

 

i have full 3 in custom exhaust i made myself no cat or test pipe, also i cut the right loop wire

 

is there any way to identify what number it is set to? if gains is set to 0 it will not function.

 

opened the controller and came to find out the ground was pretty much disconnected on the circuit board, gunna re solder it tomorrow an see what happens

 

re soldered the wire and still does the samething idk what else could be wrong other then the controller being broken