K20 piston question
DC Crew Member #1
Thread Starter
Join Date: Mar 2006
Posts: 3,128
Likes: 0
Received 0 Likes
on
0 Posts
K20 piston question
Can stock k20 pistons fit on LS rods? If they can what compression ratio would they yield?
I was thinking of putting k20 pistons on LS rods in a b20 as a cheap way to up compression but I am assuming that it can't be done.
I was thinking of putting k20 pistons on LS rods in a b20 as a cheap way to up compression but I am assuming that it can't be done.
no the answer is no , and your damn sure not gonna fit k pistons in a b20 block - deck height is different k is 86mm b20 is 84 there would be alot of custom work needed for u to even think about building a 86 mm b series
__________________
._________________________
|.....i stole the sig ................| ||
|.....from egypt boi...............||'|";,___.
|_..._...____________======||_|_|...,]
'(@)""'''''''''''''"'''"**"""""""(@)(@)*****"(@)
._________________________
|.....i stole the sig ................| ||
|.....from egypt boi...............||'|";,___.
|_..._...____________======||_|_|...,]
'(@)""'''''''''''''"'''"**"""""""(@)(@)*****"(@)
Deck height isn't a factor - that has to do with the K20 block, not the piston. The compression height of a k20 and a b series piston like p30 is the same at 1.181. The issue is the pin size. K20s use a .860 pin, while the LS/B series has a .827 pin.
i thought the k series block was 87x87 mm. i know its square bore. either way you would need a ton of sleeve work to make the bore useable, a really good head gasket to seal the thing, and like nick said, u would have to find a way to make the pin work. perhaps a set of custom rods. your best bet is the rs machine itr copy piston that they make for b20s.
__________________
RIP PABLO AKA FATHEAD.....YOU WILL BE MISSED!
RIP PABLO AKA FATHEAD.....YOU WILL BE MISSED!
i thought the k series block was 87x87 mm. i know its square bore. either way you would need a ton of sleeve work to make the bore useable, a really good head gasket to seal the thing, and like nick said, u would have to find a way to make the pin work. perhaps a set of custom rods. your best bet is the rs machine itr copy piston that they make for b20s.
k24= 87x99
__________________
http://www.inductionperformance.com/
R.I.P
Kevin "Slo_Si" Gonzalez
6/21/86-9/13/06
Pablo Garcia
9/28/85-9/05/07
You will be missed and remembered forever!!!!
http://www.inductionperformance.com/
R.I.P
Kevin "Slo_Si" Gonzalez
6/21/86-9/13/06
Pablo Garcia
9/28/85-9/05/07
You will be missed and remembered forever!!!!