Alright, im in the head of my F3, trying to figure out what size/kind of driver i should use...looks like a standard hex key should do it, but its not deep enough to get a grip. Is it a Torx bit? if so i don't have the right bit and im SOL till tomorrow. anybody with a honda should have the same/similar head bolts to help me out here...thanks.

 

Anybody???

 

nope sorry. never gone inside of the engine yet

 

Seems like you are unsure of what your doing, Might be better off in the long run to take it into the shop and having them fix what ever your trying to do.

 

i've built plenty of car motors and rebuilt SR's and know what im doing, and engine is essentially an engine, i know there are differences, but it was just my friends tools i was using was shit so i got some tools from my shops snap on rep, did the job just fine.