so I just got the engine off the rack, chained and on the engine lift. I started to putt the fly wheel and clutch plate on when i wanted to know if anyone is sure how tight to tighten the flywheel bolts and clutch plate bolts. The Hains manual doesn't specify.

 

i figured it out, i got the tranny on, bolting it up to the block. now i need a tranny mount an the right motor mount... anyone in orlando area have them?

 

so the engine was lifted and put into the bay, I started to hook up my motor mounts after i ran out and got them... when I was missing some of the studs and molts and garbage to mount up.

Now I have to take inventory and list the items i need and run out to a junk yard and or ace hardware again and pick them up.