fabrication question
Doesnt see what you did
Joined: Sep 2007
Posts: 3,683
Likes: 0
Or provide people some entertainment, being that the possibilities for how to do it were already well layed out for the OP.
Goodness, interwebs fabrication, serious bid-ness.
__________________
R.I.P. Tim 
SR, RB, and LS1 into S13/14 harnesses converted.
SR 13/13- $120, 13/14 or 14/13 $180
RB $200
LS1 $250
full on track cars can take a lot more liberties with shit than a street car. bell bottom kits and crazy wheel fitment look cool sliding on a track, but when i want to drive to taco bus, im going to ruin all of that shit. so it just doesnt work for me. function over fashion.
Originally Posted by osama tim laden
also, im about to blow my moderator status by deleteing all of davids posts
SR, RB, and LS1 into S13/14 harnesses converted.
SR 13/13- $120, 13/14 or 14/13 $180
RB $200
LS1 $250
Registered User
Joined: May 2005
Posts: 2,545
Likes: 0
if you knew zach, you would know that that IS a legitamate idea for him.
but its a complicated process, they sell these snazzy devices that go overthe tube and you push it up against your seond tube, and then it shows you the profileyou need, check eastwood
but its a complicated process, they sell these snazzy devices that go overthe tube and you push it up against your seond tube, and then it shows you the profileyou need, check eastwood
__________________
Branden Berger
352-789-0006
86.5 toyota supra- 1jz never to be finished
01 mitsu eclipse v6 5mt chick car daily
98 honda accord ex- h22 swapped daily driver
Branden Berger
352-789-0006
86.5 toyota supra- 1jz never to be finished
01 mitsu eclipse v6 5mt chick car daily
98 honda accord ex- h22 swapped daily driver
buildin' it
Joined: Aug 2006
Posts: 4,565
Likes: 0
Registered User
Joined: May 2004
Posts: 1,398
Likes: 0
i was being a dick it was a joke. seriously the answer to his question was already well laid out as tommy had said, just tring to get a few chuckles outta someone. not many ppl on here are going to have the bankroll for something that can make legit fishmouth cuts and the tooling to get the proper angles and profiles. his best bet is prob going to be to get a rough cut with a angle grinder and then smooth it out with a pnuematic rotary tool.
__________________
if you havent been in a small plane its worst, cause your eyes and brain say we are moving and your body says oh no we are not. eyes and brain go asshole we are moving, cant you see? body says fuck you we are not moving at all. so they fight and fight and eventualy your body says, you know what fuck you brain, see if you can stop this!! then you throw up.
if you havent been in a small plane its worst, cause your eyes and brain say we are moving and your body says oh no we are not. eyes and brain go asshole we are moving, cant you see? body says fuck you we are not moving at all. so they fight and fight and eventualy your body says, you know what fuck you brain, see if you can stop this!! then you throw up.
