Help water in oil..!!!!!!!!!
engine building &best
Joined: May 2003
Posts: 11,971
Likes: 0
Originally Posted by freakasis
^^^if that doesnt work you may have the headgasket upside down.
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
Thread Starter
Vtack THIS!!!
Joined: Oct 2003
Posts: 658
Likes: 0
no i made sure the headgasket was on right, and yes when i took off the head there did get water every where but i thought i cleaned it all up.......and there was smoke when i first turned on the car....what should i do?
__________________
-2008.5 Mazdaspeed3 CWP
-2008.5 Mazdaspeed3 CWP
smokes weed...everyday.
Joined: Jan 2005
Posts: 5,616
Likes: 0
Originally Posted by rangcrx
you may just need to drain the oil buy about 3 qts of cheap walmart 5-30 and just pure it tru to try and remove as much as you can
__________________
I <3 RooR!!!!!!
TR "Old Skool EF" Member #121(aka#420)
I <3 RooR!!!!!!
TR "Old Skool EF" Member #121(aka#420)
lost u already???
Joined: Apr 2005
Posts: 836
Likes: 0
like they said, i would drain it all out real good a number of times, once wont really do the trick, after you do it enough times. you need to check it again. there really isnt any hoses that you could get mixed up with cuz there isnt any hoses that transport oil. those are all cooling hoses either way. if you do that flush a number of times and the problem still remains... you have internal issues, and if your head is slightly warped, it woulnt matter if you put a brand new headgasket on there or not, it will still leak. if this all still occurs after all the flushing out you may need to take your head to a shop and have it machined flat. have them check out your sleeves. good luck with this
Last edited by integraman89; Apr 22, 2006 at 12:23 PM.
Registered User
Joined: Apr 2005
Posts: 1,222
Likes: 0
make sure that there is not water in the head bolt holes cause if there is its almost like getting water in the cylinder the water wont compress and the bolts wont go all the way down and the head wont seat right
__________________
lost u already???
Joined: Apr 2005
Posts: 836
Likes: 0
Originally Posted by jcSr20
make sure that there is not water in the head bolt holes cause if there is its almost like getting water in the cylinder the water wont compress and the bolts wont go all the way down and the head wont seat right
