ok i'll be calling for sleeve prices this week,where would be the best place to send it,or take the block to?

 

This is the kind of input I need on my setup.............good info guys

 

ISNT

 

Adam if you ever get time call me up I have a boy who is a sick ass welder who makes his own piping we can swing by his house and we can see his set-up. Also I would call around get some input from different shops in Ca i.e. redline(San Diego), honda acura performence(Long Beach), and OH, Simon(Coloumbus) racing talk to Mike, Passen motorsports(Columbus) talk to anybody and local, secret services, Collin, RPI out of Orlando.

 

Like I said, AEBS is the best in my opinion (tested to 55psi PLUS!) but you get what you pay for.... My second suggestion would be Golden Eagle.... Talk to a couple other people and see what they think, and not downing anyone, but people who have done their research lately should agree, these two companies are two of the best out right now as far as product AND customer service which in my book is just as important...

 

 

OK, I won't start shit, but I have to disagree with him politely... I think Honda motors are pretty damn strong... I accidently ran 15 psi with an air fuel ratio so lean it dropped to the last red bar on my gauge, and didnt fuck a damn thing up... Not saying its smart but it was a pretty good accidental test that Id never do again... 15 psi from a 60mph (third gear) to about 130 mph (in fifth) at 100 % throttle the entire time, and the motor still runs as hard as ever..... Didnt even foul a plug.... 20 psi on a PROPERLY built motor with a safe a/f ratio, will barely tickle it....