pls let me know where this is cuz i need them before terry and i finish up with the install of my bottle for the meet next weekend

 

anywhere. they are copper plugs ngk power 7's. Automotive enginering,gearhead you could probably get them at your local auto parts store. gap them to 28-30.

 

thank man..........i will probably be PM'ing you about the install of these tomorrow........is the gap measurement specifically for the nitrous application or is it overall??? Like would I have to change them right back if lets say i decided to go all motor..........would i have to regap them again???

 

The gap is what works best all around so you will be fine. Dont forget to check your timing. You want it at 14 degrees for nitrous.

 

I need the gun to measure this right...........where would I get one of these from???

 

No thats right. I all ready looked for it. It must have been thrown away with all the other stuff in side the car. You know that yellow pro-tools van that pulls it wheels down the track. Well I dusted him out of the hole right before " it went " . Don't worry my hatch will be back. I will let you know as soon as it is ready.

 

My stock valves are fine. Even after 160 shots down the track. I uses stock plugs.

 

Whats wrong with that? That is what I use. Seven times in one night at the track.

 

Thats reggie in the pro tool truck. I'm not trying to be a dick to you but leaving him at the line means nothing. My best is a 1.64 60 ft. I have yet to see any honda (fwd) pull a 1.49 60 ft. That would take alot of suspension work if even possible. Good luck getting the car back on the road. I look foward to seeing you at the track. Ps if you pull another 1.49 go ft i would lose the slip. Those are hard to come by.

 

Your right. That picture was taken back in November. It has come along since then. Are you going to the H/A meet in Bradenton. If so I look forward to meeting you in person.