sooo measure the pad? if the middle of it exceeds .004" ? I see...


ohh ok wow .0006" that is pretty tight but I guess you really do want them flat...

 

look man if you do not know where or where to measure then you will def have a margin of error greater thean what you are looking for. take them to napa ask to have them resurfaced. if they are to thin they will tell you.
it is a good idea when doing a brake job as it will help eliminate any squeeks etc..

 

the bigger the vechicle the larger the tolerance for run-out,a huge truck will not be affected by .006" run-out ,but on a civic or something of similar size a .005" should be machined. and Bob, i'm prettey sure you made a mistake ...its more like .006" and you can still machine it if its in spec.
and you want to measure them in the deepest groves doesnt matter exactly where ,as long as the measurements are spread out.
and please for the love of god, dont go to any so called "brake Speacialist " places .they will just fuck you for your money.

 

Awright, fourbanger! I copied my numbers right from the book, and just checked another book, ...........and both read the same................

Sooooo.......I called all the autoparts places near you, and told them what you said about the manuals they sell.........

To a man, they all said they would kick your
A--, next time you walk in! -Bob

 

Go to Bobby Ralston at S and R Performance. 813-961-0609

Tell him that guy with the Viper sent you.

 

rotor discussion
ttt