Originally Posted by Whaazup17

yea milling would definitly be the way to do it. It isn't that hard to mill it. The problem that you would face that would be the most difficult is how to mount it. From what I thinking it is a 4 cylinder manifold so it has some funky twists in it and everything. That is the problem you would have. The cutting is not difficult.

and if you get it done by a machine shop make sure they prove to you with a dial test indicator it is flat say within .001"

Originally Posted by GsEclipse02

do you know of any??

Originally Posted by whtmustangt99

you do it? if so how good are you? i see it says your in training in your sig could u do it withing the .001 without butchering the manifold? (not questioning your ability since i dont know you just checkin)

Originally Posted by whtmustangt99

you do it? if so how good are you? i see it says your in training in your sig could u do it withing the .001 without butchering the manifold? (not questioning your ability since i dont know you just checkin)

Originally Posted by AnTman86T

Kelly's Machine shop.

Originally Posted by Whaazup17

yea me but if not there is plent other guys. I know of a personal friend that has been doing it for 30+ years but he'll charge you. He works out of his house.