exhaust cut outs
Banned
Joined: Jan 2004
Posts: 17,444
Likes: 0
Originally Posted by Billy
Once you weld in the Y-Pipe it will fit any car Frank.
I was recommended the DMH by someone who owned a set of QTecs and was wanting to get rid of them for the DMH. We compared my DMH side by side to a QTec cutout and the DMH looks to be much nicer. It has a machined lip for the butterfly to seal against as opposed to the Qtec that you could see the gap and light coming through from around the butterfly. The DMH also opens faster and uses a smaller, lower profile switch.
I was recommended the DMH by someone who owned a set of QTecs and was wanting to get rid of them for the DMH. We compared my DMH side by side to a QTec cutout and the DMH looks to be much nicer. It has a machined lip for the butterfly to seal against as opposed to the Qtec that you could see the gap and light coming through from around the butterfly. The DMH also opens faster and uses a smaller, lower profile switch.
No "V-TECH" here!!!
Joined: May 2004
Posts: 2,320
Likes: 0
Originally Posted by Little Nicky
IMO cutouts on imports are the ewww
__________________
You can find me at the Track!
KJ built
ALPHA TUNED
Induction Performance 727.505.1423
* Engine Management Tuning, Track Setup, Consultation, Turbo Sales, Parts Sales (WorldWide)
^^^
ONLY SHOP IN TAMPA THAT TREATS YOUR CAR AS THEIR OWN
You can find me at the Track!
KJ built
ALPHA TUNED
Induction Performance 727.505.1423
* Engine Management Tuning, Track Setup, Consultation, Turbo Sales, Parts Sales (WorldWide)
^^^
ONLY SHOP IN TAMPA THAT TREATS YOUR CAR AS THEIR OWN
Thread
Thread Starter
Forum
Replies
Last Post
Scott
Ford, Lincoln, Mercury Tech
2
Nov 20, 2002 10:31 PM
