stall
Cracka-Faced Cracka!
Joined: Jul 2001
Posts: 1,951
Likes: 0
im not sure..its either a 9" or a 10"....i forget..its a 3800 with an anti-balloning plate(for N20)
__________________
AIM: AIMisGOOP
AIM: AIMisGOOP
Originally Posted by moldyhands
in the immortal words of the very wise Kid Rock, "3 foot tall with a 10 foot dick"
though for me, you'd have to change it to 10 inches, and you'd have to change inches to millimeters, and you'd have to change 10 to 5 and you'd have to change dick to poor excuse for one.
though for me, you'd have to change it to 10 inches, and you'd have to change inches to millimeters, and you'd have to change 10 to 5 and you'd have to change dick to poor excuse for one.
Need To Get Quicker
Joined: Dec 2001
Posts: 894
Likes: 0
If it's a C-4 your talking about, then most likely it is a 26 spline, unless it is a real old one and then it might be a 24 spline. If it is a 24, get a new 26 spline input shaft and drum for it. The 24's don't last long.
Post a copy of the dyno sheet. That cam sounds a little small to make power that high up in the RPM range.
Post a copy of the dyno sheet. That cam sounds a little small to make power that high up in the RPM range.
Daddy-O
Joined: Aug 2001
Posts: 3,300
Likes: 0
Originally posted by "racingtheburg"
never got the chance to take taylor up on his offer at the dyno but its a 68 tranny i think mine is 3800 is tooo big i found out btw ts dude lol im back some time i need parts!!!!
never got the chance to take taylor up on his offer at the dyno but its a 68 tranny i think mine is 3800 is tooo big i found out btw ts dude lol im back some time i need parts!!!!
pm me with ur email addy or im addy
