This is what the two Cheetah shifters I had came with.

 

Here's the one I have. no numbers on it and the bolt is missing but it's just a bolt and nut. I can probably find one lying around that will work. $15

 

so the one on ebay i listed up is the one you had? did it shift fine.steve at CRT told me to make sure its the right one cause some of them will allow it to get stuck in between gears

 

Turbo Action shifters for the Fords have there own specific shaft/lever and pan bracket(the B&M cable bracket will not hold the morse cable that Turbo Action uses)..... The Turbo Action one unscrews, none of the factory ones do(you needed the shaft from the other trans)..... Here is a pic from there site instructions.....

 

yea the pic you listed is how my other c4 looked.the new one the shaft is way diffrent.i have looked for the new shaft like the one in the pic but im not able to find anyone that sells it.

 

We just used the other one you posted when Cody put the C-4 in his car.
I works fine. This shifter set up came from Mikey's turbo Crapi

 

this is the one you guys used? everything lines up fine?

TCI-418400 Shift Lever Steel Ford/Lincoln/Mercury C-4/6: eBay Motors (item 330482627094 end time Nov-08-10 00:27:24 PST)

 

Y-e-s-s-s!!!!

 

thanks

 

If you are allready buying a new shifter arm. Get the 1 with the slot all the way up and down the middle. it will make setting it up and adjusting the shifter alot easier. I will try to find a link.