How do I solve THIS problem?
Thread Starter
banana republic
Joined: Jan 2008
Posts: 8,819
Likes: 0
TR Balla Donor Supreme
Joined: Oct 2007
Posts: 273
Likes: 0
They are both out of the car. They both have full pans too. 
So it's going to be a bitch because I have to try to do it all in the rain and on the ground. No table for me.
I need a general consensus here.....Will the arm that Dr. Dirt has WORK in this application? If it will, that sounds a LOT easier.
So it's going to be a bitch because I have to try to do it all in the rain and on the ground. No table for me. I need a general consensus here.....Will the arm that Dr. Dirt has WORK in this application? If it will, that sounds a LOT easier.
that linkage will not work with the stock shifter,as it is not the same length of the stock rod.
I can fix your bullshit
Joined: Oct 2005
Posts: 2,998
Likes: 0
you also need to make sure the tailshafts the same driveshaft may not fit but you can swap it from the broken one
it has been awhile since i did one also but i dont remember it being that hard...pull pan on broken one first abd play around with it its already broken..its not that bad to do...
it has been awhile since i did one also but i dont remember it being that hard...pull pan on broken one first abd play around with it its already broken..its not that bad to do...
__________________
Thread Starter
banana republic
Joined: Jan 2008
Posts: 8,819
Likes: 0
I think he was simply using it as a trans plug. LOL
Thread Starter
banana republic
Joined: Jan 2008
Posts: 8,819
Likes: 0
