Cam

Reply Subscribe

Thread Tools

Sep 3, 2006 | 02:03 PM

#11 (permalink)

69Boss521

Thread Starter

PORK CHOP SAMICHES!!!!!

Joined: Dec 2003

Posts: 2,840

Likes: 0

Thanks Andel. Those heads you sold me breathe a hell of alot more than the ported iron ones....

Sep 3, 2006 | 02:26 PM

#12 (permalink)

bigjim2.5

Registered User

Joined: Nov 2003

Posts: 1,169

Likes: 0

I have a comp Xtreme energy XR294RF believe that is the part # it is a retrofit hydrolick roller cam is new asking $175 was going to run it in a 393 myself before I sold the motor

__________________

Sep 3, 2006 | 02:31 PM

#13 (permalink)

69Boss521

Thread Starter

PORK CHOP SAMICHES!!!!!

Joined: Dec 2003

Posts: 2,840

Likes: 0

what are the cam specs on it? Do you have the lifters or just the cam?

Sep 3, 2006 | 04:58 PM

#14 (permalink)

bigjim2.5

Registered User

Joined: Nov 2003

Posts: 1,169

Likes: 0

just the cam I'll open it and get the cam card out you can use stock 5.0 lifters I probably have a set of dogbones and a spider laying around

__________________

Sep 3, 2006 | 06:21 PM

#15 (permalink)

69Boss521

Thread Starter

PORK CHOP SAMICHES!!!!!

Joined: Dec 2003

Posts: 2,840

Likes: 0

Do I have to change the pushrods due to length?

Sep 4, 2006 | 03:34 AM

#16 (permalink)

69Boss521

Thread Starter

PORK CHOP SAMICHES!!!!!

Joined: Dec 2003

Posts: 2,840

Likes: 0

Shoot me a PM jim when you have the cam specs.

Sep 4, 2006 | 11:12 AM

#17 (permalink)

bigjim2.5

Registered User

Joined: Nov 2003

Posts: 1,169

Likes: 0

depends on the length you have you might I have done 2 that did you stock length push rds I have a push rod checker you can borrow if you decide on the cam. I'll have specs this afternoon

__________________

Reply Subscribe

Reply Share

First
Prev
2 / 2
Next
Last