Engine/Tranny pull
Mechanical Engineer
Joined: Nov 2002
Posts: 3,094
Likes: 0
nevermind then, i didnt know your motor was that fresh
sorry
sorry
__________________
Mechanical Engineer - Naval Surface Warfare Center PCD, Marine Corps. Counter IED Development
USF Formula and Baja racing Alumni/Consultant
Mechanical Engineer - Naval Surface Warfare Center PCD, Marine Corps. Counter IED Development
USF Formula and Baja racing Alumni/Consultant
has his prioritys ef'd up
Joined: Mar 2004
Posts: 2,450
Likes: 0
Flywheel is 75-85 #'s of torque, pressure plate is 12-24, bellhousing is 39-54, and tranny to bellhousing is 36-50. And also, whoever told you to remove the engine to do a clutch swap is an absolute dumbass.
__________________
Ryan
1990 Mustang GT (In Process)
1993 LX Coupe (Daily Driver, but just choose not to)
2005 Excursion (Big Pig)
Ryan
1990 Mustang GT (In Process)
1993 LX Coupe (Daily Driver, but just choose not to)
2005 Excursion (Big Pig)
has his prioritys ef'd up
Joined: Mar 2004
Posts: 2,450
Likes: 0
Oh and the driveshaft is 75-90 ft/lbs of torque. Good Luck its easy anyway.
__________________
Ryan
1990 Mustang GT (In Process)
1993 LX Coupe (Daily Driver, but just choose not to)
2005 Excursion (Big Pig)
Ryan
1990 Mustang GT (In Process)
1993 LX Coupe (Daily Driver, but just choose not to)
2005 Excursion (Big Pig)
