i got a 96 jetta vr6 and i dont know that much about the specs of my stock engine.. im plannin on turbo'in it soon and i want to know wut kind of injectors to run and stuff like that?? or wut is the most can i leave stock and how many psi's can i run??? thnx for any help

 

I hear APC makes good injectors.

 

You will need high impedance top feed injectors. For 6 cyl engines the cc's will equal the supported hp at 43 psi of fuel pressure, so 315 cc injectors will support 315 hp

Your stock injectors with added fuel pressure should support 250hp without a problem. I would look at how much hp you can run instead of how much psi you can run.

 

10 PSI is about the limit on the stock headgasket. Check C2 motorsports for a fueling kit. I hope you like one wheel peels with that open dif.

 

thnx for the info..im not really trying to spend an ass load of money.. im just trying to figure out how much shit i can leave stock and wut i DO have to upgrade..thnx

 

also i want to do a front end golf conversion.. wut all do i have to change??

 

Fenders, headlights, grill, hood.

And to answer your other post, you can leave everything stock and turbo it, but you will ruin you motor doing so. If you want to do it cheap, it won't last long and you will have a bunch of problems.

 

wut do think think most psi or hp do you think i can run on just the stock motor

 

I already told you, 10 psi is about the limit with the stock headgasket. The motor will be fine if it is maintained and the car is properly tuned after being turbo. If you try to cut corners it won't run properly and the motor will fail.

 

my buddy pushes 12psi on his stock Vr . . . intercooled. That thing runs worst past 10psi . . . So keep it 10 or below.