Isuzu motor swap.. 350 or v6. where to find mounts!
Fail
Thread Starter
Join Date: Jan 2005
Posts: 651
Likes: 0
Received 0 Likes
on
0 Posts
Isuzu motor swap.. 350 or v6. where to find mounts!
anyone know where i can find motor mounts for a 350 swap into an isuzu pickup truck. Im looking to go with a 350 i have already or a vortec v6 out of a chevy s10. lmk if you have mounts or can find mounts
Fail
Thread Starter
Join Date: Jan 2005
Posts: 651
Likes: 0
Received 0 Likes
on
0 Posts
Registered User
Join Date: Jun 2005
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
i had this same exact idea a few hours ago while trying to unbolt the bellhousing from the block on a 91 Isuzu Pickup so we could get the oil pan off and found out how much of a pain in the ass it is. we were joking about doing either a 350 or 5.0 swap so if u decide to go through with it please make a post about it
Fail
Thread Starter
Join Date: Jan 2005
Posts: 651
Likes: 0
Received 0 Likes
on
0 Posts
i wish someone made a mount kit for it it would make shit so much easier.. i got a 383 stroker im thinkin about putting in my 93 isuzu
Registered User
Join Date: Jun 2005
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
what tranny r u planning on using
Fail
Thread Starter
Join Date: Jan 2005
Posts: 651
Likes: 0
Received 0 Likes
on
0 Posts
Registered User
Join Date: Aug 2002
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Your best bet is using a front motor plate, I dropped a SBC in a Suzuki Samurai and that was the best route as it gave me plenty of room for exhaust( used Ram horn manifolds)
Fail
Thread Starter
Join Date: Jan 2005
Posts: 651
Likes: 0
Received 0 Likes
on
0 Posts
