Well guys, was up all night putting the tranny back in. Kind of a horror story. So check this out! I was bolting everything up, had the tranny bolts on tight, drive shaft on, axles in.... Then i go to put the slave cylinder on and believe it or not, i drop on of the bolts in the starter hole. I was fuckin pissed. So i had to pull everything back off. I was up till 4 AM putting it all back together. Fuckin UPS didnt drop the tranny off till 7 that night. Anyways, she is running. My passenger side axle is leaking just a tiny bit i think. So im working on that right now. HOLLA

 

good to hear man, you have to be a tranny specialist by now

 

if is not one thing,is the other. but glad to hear that is running already. Kyle is almost done w his too right?

 

that sucks ryan, you couldn't get it with a extend-o-magnet?

 

no i couldnt, i tried everything. So i just pulled it out to play it safe. Kyle just told me he is getting his clutch this week.

 

Dude that sucks. I hate that. I went thru the same thing when I installed my new motor and found out after I had the motor in that the motor mounts were wrong. Had to yank the motor out to fix the problem.

Hope you dont have any more snags man.

 

only snag is i think im about to snap the damn tranny mount in half HAHA....

ordering one tomorrow! HEHE...

 

magnet wouldnt get the bolt?

 

gotta go to tampa to see if i can get the pressure plate resurfaced then buy a new disk! then me and ryan are gonna have the beast back up and running.... finally then i can get the full tune

then me and ryan are gonna ride out if anyone would like to join

 

hell no man! do you know how tight the fit is. you cant even stick a magnet in there because of the angle! its all good. i got the car together now.