and I'm spent

How To: DIY TGV Deletes - NASIOC

 

will i be able to get this done in an hour or so?

 

I read somewhere it took 2-3 hours(Nasioc thread)

 

hmm sounds good i rather do things myself especially when ive machined a lot more complicated things from scratch then this... and ill be sanding and painting the intake manifold at this time also maybe ill leave it polished if that looks good but if not its going black... and yet more questions where cani get and how much for the gaskets

 

Gaskets for intake to TGV were like $19 at Mastro. you may not even need these being so new...

The other ones you should replace with the Hondata, nextgear, crucial or Cometic thermoshields to keep the heat out of the top end. about $60

 

thanks dudeman for the help.. so can i do this now and when i get my new turbon with 3'' inlet.. all id have to do is replace the manifold to tgv gasket, since the other expensive gasket wont need to be touch i wont have to replace that right? and where do i get the ones that cost 60?

 

Make a replacement set... from billet aluminum

 

that would be sick to make your own

 

that would be nice but my car would be down for a week since i wont have a lot of time to work on them but it would be nice if i can get a set of extras to use for the measurments i can cnc some

 

you got me all confused... Actually you may not need any of the gaskets at all, your car is still pretty new.

I got the hondatas from a vendor on clubwrx.net lots of shops sell them.