View Single Post
Old Jun 11, 2007 | 02:34 AM
  #6 (permalink)  
Rotary Buddha's Avatar
Rotary Buddha
zero pistons
 
Joined: Aug 2004
Posts: 770
Likes: 0
Default

Originally Posted by Yokomo
I need a lot of parts so it's going to take a long time for me to buy everything.
I need...

Interior parts-
Center trim with A/C vent at the top
A/C vent for the top of the dash on the passenger side
Gauge cluster with about 130k on it if that's possible
Rear speaker mounting brackets
All the speakers
Sparco driver seat
Any misc. interior screws
Working antenna
Stock radio with tape player
Maybe a 4 point or 6 point roll cage

Exterior parts-
1 tire for the stock GLX rim
S5 tail lights
Passenger and driver side window trim that's not rusted
Wiper arms that also aren't rusted

Engine parts-
Racing Beat header
HKS or Apexi exhuast system
Everything that I would need to convert back to fuel injection
460cc high impedence injectors
Fuel rails with Pulsation dampner and one with Fuel pressure regulator -s5 N/A Mass air flow sensor
N374 or equivilent boost sensor
Stock lower intake manifold
upper intake manifold
Throttlebody with tps's
S5 N/A wiring harness
6port sleeves
Crank angle sensor
TB cap and intake duct
Emissions rack
S5 electronic oil metering pump + lines and injectors

I know that's a lot of stuff but it's what I need. This coming pay check I can't do much, but after this one I'll have enough for almost everything. I'll be taking things off as I get them.
Thanks for looking!
Did you not read the other post I made in your thread. You have some of that stuff already.

https://www.tamparacing.com/forums/m...elp-my-s5.html
Reply