Valves
Registered User
Thread Starter
Join Date: Jul 2002
Posts: 9,270
Likes: 0
Received 0 Likes
on
0 Posts
Valves
I'm on the last stages of my head build and need some recommendations.
I was told that there would be NO benefit using Ferrea stock sized valves over stock B16 valves.
If I got the Ferrea valves I would want to get the bronze valve guides too (due to wear) and that means I would have to take a trip to the machine shop =/
Also, Tom from Port Flow recommended I just run the stock B16 valves since I have good valve springs (Port Flow inner and ITR outer).
What are your thoughts?
I was told that there would be NO benefit using Ferrea stock sized valves over stock B16 valves.
If I got the Ferrea valves I would want to get the bronze valve guides too (due to wear) and that means I would have to take a trip to the machine shop =/
Also, Tom from Port Flow recommended I just run the stock B16 valves since I have good valve springs (Port Flow inner and ITR outer).
What are your thoughts?
__________________
- Induction Performance
* IP E-Mail
* IP Face Book
* IP Web-Site
* RIP Kevin/Slo_Si RIP & Pablo/Fathead
- Induction Performance
* IP E-Mail
* IP Face Book
* IP Web-Site
* RIP Kevin/Slo_Si RIP & Pablo/Fathead
Registered User
Thread Starter
Join Date: Jul 2002
Posts: 9,270
Likes: 0
Received 0 Likes
on
0 Posts
Ahhhh ... My mind is at peace now. I can put the money towards my intercooler this week >=]
__________________
- Induction Performance
* IP E-Mail
* IP Face Book
* IP Web-Site
* RIP Kevin/Slo_Si RIP & Pablo/Fathead
- Induction Performance
* IP E-Mail
* IP Face Book
* IP Web-Site
* RIP Kevin/Slo_Si RIP & Pablo/Fathead