OK So I am wiring my Ka F3 plug to match a JDM F4 plug (both harnesses are from a 95 Zenki). Since I need my car running and the Rb won't be done for a few more months, I gotta work with this.

I went through both Fsms and got, for the most part, all the pins repinned to match the JDM harness plug. I just have a few pins I am still not sure of. The fsm's for Jdm and Usdm have different verbiage. Before I start this up and possibly fry shit, I would like to know if anyone knows where these USDM pins would go to on the JDM pins or vice versa (and if any are deleted, etc, etc)

Also, being new to this mess, of the pins that list GROUND on them (whether from plug to plug or plug to ecu) could I just find a Black ground pin and match them up to it? Sounds like a noob question, but I never had to wire Usdm to Jdm before.

Here is a picture with what pins I am missing, left over, and is confused.



Uploaded with [URL=http://imageshack.us]ImageShack.us[/URL


Any help is deeply appreciated!

 

When I do my swap I'm getting my harness done by Nissan/Datsun Wiring Harnesses nothing but good stuff posted about their work all over the net. Try emailing your question to them I bet you'll get a answer.