o2/egr block off
Thread Starter
cant slide
Joined: May 2008
Posts: 2,441
Likes: 0
o2/egr block off
hey, i have sr20, on the stock downpipe elbow, theres 2 bungs, top bung is for o2, the other one is open on my car and i wanna plug it. does anyone know what size bolt to use? could i use a rear diff. drain plug from an xterra or something? (an idea from tim) lmk, stupid loud crappy exhaust leak
__________________
contact admin@tamparacing.com to advertise on here.. - mod
contact admin@tamparacing.com to advertise on here.. - mod
no
Joined: Mar 2007
Posts: 3,328
Likes: 0
Buy an aftermarket o2 housing, gain power and lose shittyness.
Registered User
Joined: Apr 2009
Posts: 1,420
Likes: 0
+1 aftermarket
__________________
Sullivan Racing LLC
352-665-2496-Tom
SullivanRacing06@aol.com
my lag is your courtesy head start
ATTENTION.... installing a head gasket, head studs or pistons and rods in your otherwise STOCK engine dose not make it a "built" engine! stop listing you cars for sale saying they are built when its not!!
Sullivan Racing LLC
352-665-2496-Tom
SullivanRacing06@aol.com
my lag is your courtesy head start
ATTENTION.... installing a head gasket, head studs or pistons and rods in your otherwise STOCK engine dose not make it a "built" engine! stop listing you cars for sale saying they are built when its not!!
Thread Starter
cant slide
Joined: May 2008
Posts: 2,441
Likes: 0
i am, but not yet lol
does anyone know what size bolt, or plug that will fit in there? i need a quick fix for now. ill weld shut later, my freind has a welder i dont
or if anyone has egr tube laying around i can screw it in with a nickel, or weld it shut, idfk
does anyone know what size bolt, or plug that will fit in there? i need a quick fix for now. ill weld shut later, my freind has a welder i dont
or if anyone has egr tube laying around i can screw it in with a nickel, or weld it shut, idfk
__________________
contact admin@tamparacing.com to advertise on here.. - mod
contact admin@tamparacing.com to advertise on here.. - mod
Last edited by markstheman365; Dec 24, 2010 at 01:44 PM.
