cant figure out why the cluster wont come on, its getting power but i dont know where its grounding out at

 

^^true...might as well just order some motor mounts too.

 

of what the clutch disks? i know the lines are for the 4wd system, but i wasnt sure if they were all needed. Went back through and it looks like i got all the Hicas stuff out.

 

oh and tried to get those 2 rear bolts on the shifter plate again but.....no....damnit.

 

Of the clutch discs. I can usually tell by looking at them if they're in right. McLeods are the same way.

 

dude, if your not doing anything serious you dont need those last two bolts

i didnt have them in on my last two cars, and i only have 3 in my POS ka car right now.

 

i already have the clutch out. i just need to get a install of how they are suposed to go. i am not 100% sure what way the disks go.

 

Unless they're marked "flywheel side" or something to that effect, it shouldn't matter too much. You have to look at the disc face itself and see if there is a definite difference between front and back. There is only so much one can do without pictures.

 

yea i got yea man.

been looking @ the Exedy website for install instructions. i htink i should be able to figure it out. i am going to clean up all the stuff today, and get it in there.

 

good to know, but they're not coming out. once they're out im throwing them into the street.