i need to make a rail (meaning, have someone make me one) for my car too.
just doesnt seem to be happening.

 

Went to the hookah bar meet last night, on the way there my buddy Louis was yelling at me that I was dragging something. As we came up to the red light, I went to try and look at which point he was like its just a rag or something.

So I figured I picked up a shop rag on the way out of my garage, and it got stuck somewhere. Well I woke up this morning and was like hey,lets go grab this rag out from under my car.



Apparently, its not a shop rag.

 

BAH I've got the rails, I just need to swap them between the two seats, the seat bolted to the drivers rail I want on the pass side, and vice versa.

Nothing bolt on available to do what you want ?

 

He has an SRD and is trying to get rid of the problem I had. All aftermarket rails for that seat make the thing sky high. So the only way to make it work is to basically mount it on the floor.

 

what is it

 

Dead squirrel ;_;

 

With my modified NAMS rail, my Sparco Roadster is touching carpet. You're not going to get it much lower than that.

 

The problem is the SRD is bottom mount, and the lower seat section itself is 2-3" thicker.

 

well the car has been acting funny lately so i did a tune up on it a few weeks ago and it still is acting up so today i bought some fuel injector cleaner if that dont work 3 gallons of race fuel mixed in should work lol

 

im getting rid of the slider, and probably mounting it behind the square on the floor, fixed mount.
so, ill be the only one that can drive my car, seems like it should work.


i think i passed mewantkouki on i4 today, headed the other way near haines city.