they should suck in a little bit normally.

 

yes

Mike:

machine shop - Google Maps

 

it was enough to draw my attention to it, when it never has before... i hope its just something with me running the thicker disc in the hyper single. ill find out in a week or so i guess


oh and dan as far as headlight clearance i dont think it will be too bad, im going to run my hot pipe through the frame rail where the factory has the hole there with the plate over it (just have to make a slight cut) and then through the same area the usual hotpipe runs.

 

170 shared_pm me, ill pull it this week but idk if ill get it to dans or not but we can meet also.

 

wohoo party at my house.

 

Things have changed in marks shop lately. All i have to say is that 4 of my friends who have sent about 30+ motors through that shop in the last 10 years are all taking their business else where as of the last two months.

if you want more info, PM me.

 

Does any one have one of these factory S14 air duct thinggys?



If so I want it.

 

I'm supposed to be getting one from OneCleanS14, but I think he's been dodging me.

 

i threw my old one away sorry dan.

OT: made a trip by amazon and ended up 35 bones poorer for 6 hose clamps, some oil line, and fitting. ugh

 

I have a cut up one since my old intake ran closer to the radiator side rather than all the way to the corner.