for an s13 id go with 18x9 +5 front with a 225/40/18 and 18x10.5 0 with a 265/40/18 youll be baller.

i disagree with importluv because there is a correct offset. for instance if you run a 9.5 inch wide wheel with a low 30s offset youll never clear your coilovers (if your running them) on a 240 running high offsets is pointless it just makes for shadows and clearnace problems.

check into a wheel made by axis, they are called the wde tracks. you can get them in 4 lug. they are 18x8 +20 and 18x9 +20. they will fit easy all day long no rolling or pulling. i think thats about as aggressive as your gonna get. or just buy some mustang wheels off ebay lol.

 

what a ground breaking and insightful question.
thank god someone brought up this never discussed topic.

 

17x10 +12 all around. do it.

 

And thank you for being a cock bag. Your insight is astonishing.

 

Who the F are you? #1 18's don't belong on 95% of the S13's out there. #2 a 10.5" +0 with a 265 won't fit on any S13 without a +50mm fenders. #3 we're not talking about baller. We're talking about non-staggered, decent setups. This is exactly the garbage I'd expect from someone who's sig is a mile long with dead links and formatting errors.

A good non-staggered setup is my old 16x8 +30 with 225/50/16's. Also, someone makes a similar wheel with +25, which also works. Yeah, it was a little sunken in the front, but it didn't look bad in the least. The rear was pretty close to the fender. 17x8 +35 FN01R-C's with 225/45 doesn't look too bad either. If you're looking at 17x7.5 +32, that's a decent street setup. Flushness can be made up for with tire width, to some degree. A 225 on those wheels would be nice. You don't need stretch to have a decent wheel/tire combo.

 

Thanks for the info epstein. Thats the exact info I needed. It's hard to find info that isn't for staggered wheels or for pulled/rolled fenders.

 

qft.
18's are just too big.
and this thread is posted about once every three days.

 

Even if its not completely flush, small spacers can make it look better.

 

I thought this offset discussion was worth bringing back