as most of you know i am doing a widebody and paint and stuff so i need to rims as well the set i was looking at are 17x9 +32offset my question is how far will these stick out in the front with the sil front end and im getting the front fenders rolled and probably a 30mm spacer for the rear would theses fit ok? im only doing maybe a 3/4 inch fender roll

 

maybe this will do better in drifting forum

 

depends how "widebody" you have... +32 offset is decent...but usually i see widebody 240sx's running more of a 17X9 +9 offset up front, thats using a 15mm pattern changer/spacer... Not sure if the +32 with the 30mm will cancel each other out...Matt could tell you everything about offsets, so could taylor...chime in guys.

 

17x9 will rub with anything higher than a 25 in the front. So I would recomend getting something with a lower offset if you are doing widebody. Stock fenders hold the A-TECH 17x9 17 offset in the front, so shoot for that goal. If you are hellbent on using the 32 offset you would have to get a 15mm spacer in the front, and then roll it slightly then it will look ok.