I would love know that site as well.

 

I found it earlier today and emailed them. Someone must have been spreading mis-information though, they emailed me back and told me that they can match factory colors but cannot make any for high-temp apps. Looks like it's back to the drawling board for me.

 

i know u from school , friends with sean... , cameron

n e ways it looks nice

 

i cant remember u, u said ur name is cameron

 

Looks GREAT! What we need next is a picture of the valve cover installed with a shot of the whole engine.

The only down fall to using spray paint is that it doesn't hold up to any abuse. From experience, be real carefull putting the valve cover back on, don't scratch it.

 

To add...

DAMN, you took a lot of time getting the lettering and logo taped up, PROPs to you on that. I've tried to do that in the past, man, talk about a pain in the butt. To save time, I've also used sand paper and a block to sand down the lettering, but if you don't take your time with that, you can scratch the rest of the paint very easily.

Again, looks great!

 

I agree wih Ian, you did a great job on it.

 

It looks great. Good luck with longevity.

 

Very Nice.. Clean ride.

 

thanks guy..........ya the letter took around 40 mins to get right but i knew the time would pay off...........i was VERY careful when i put it back on...........went on smoothly, polished it up with mothters today and the finish is immaculate..........and the finish will last very long......Just gotta take care of it. The vc has been heat treated and ive worked with this stuff b4 and u gotta kinda just take care of it like u do with regular paint......Ive learned this over time............Ive already got like 5 ppl that want me to do theres for them.........I cant wait to grad from highschool so i can go to uti and really get my hands on this stuff