18 - 19 psi built sr20de?
Nice! So you like that evo? I been thinking about one but im not too sure. It would suck starting over again and getting rid of this car wont be too easy. Well, i dynoed the other day and this is what i got on 19 psi of boost.
__________________

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....
Thanx, its decent.
Norlandt
Norlandt
__________________

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....
well if its only decent...i'd wait till its running perfectly...after all that shit you went through with that motor! I'd just drive it on 12-15...don't get too greedy.
__________________
NOBAMA!
NOBAMA!
Yeah, i know the tranny is going and i think the motor mounts are too lol. What ill probably do is just run around the corner to sunoco and put some 100 octane in there to run 19 psi.
__________________

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....
Ok thanx. Also, i pulled the plugs today and looked into the cylinders and saw that all pistons were covered in carbon but one. Number 3 i think. It had little tiny dots of carbon but thats it. Any idea whats going on here?
__________________

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....

http://inductionperformance.com/
Induction Performance - 727.505.1423
AEM EMS Tuning, Builds, Assembly, Custom Kits, Installs and more.....



imo. keep the highpsi for good reasons.