DOHC in SOCH s13
Thread Starter
HoHo's
Joined: Jun 2002
Posts: 36
Likes: 0
DOHC in SOCH s13
Got a few question my brother is doing a Dohc swap into a soch s13. Everything went smoth exept for the gauge cluter harness. Any info on that would be greatly appritiated. I got the brown plug from a DOCH but if you guys could make my life easier and tell me what the wires are it would be done today!
__________________
2640lb.
227.5 RWHP
2640lb.
227.5 RWHP
Retired
Joined: Jan 2003
Posts: 5,095
Likes: 0
Hmmm, looks like you should hook up the following:
Blue/green = AC signal
Yellow/green = speedo
Yellow/Red = tach
Orange = Ignition
The red wire goes to 2 different places, so don't use it. The green ones with whatever/no stripe go to the Consult port (which no one uses). The black one is the ground for the consult.
Blue/green = AC signal
Yellow/green = speedo
Yellow/Red = tach
Orange = Ignition
The red wire goes to 2 different places, so don't use it. The green ones with whatever/no stripe go to the Consult port (which no one uses). The black one is the ground for the consult.
__________________
5 Foot Fury
Joined: Jan 2003
Posts: 14,247
Likes: 0
