So as most of you know or have seen my rebuild posts, I've been cleaning up a horribly rigged gst spyder... So the car was wrecked atleast twice in the front driver's side, before I got it. Well on the drivers side there is a wiring harness that has a plastic case that covers it while it goes from the fender to radiator support. That plastic piece is complete smashed and covered in oil. So I took al the electrical tape off to find this bs...

Does mitsu do this crap from the factory? Have one wire connect to three like this?



Are these wires suppose to be together?











This is the alt plug... So I have no idea how anyone could pull this off. But any ideas how to dissemble it or where to get a replacement (junk yards don't have any in the polk)









So basically what is the best way to fix this crap? Any knowledgeable ideas would be great!

 

buy a new plug?

 

What is the car doing that you're trying to fix? As for the plug...just go to LKQ or something and root around a few old Mitsubishis to see if you can find a matching plug..