Does anyone know how to install a 14b on a 2g w/o the 200$ install kit?? i know it can be done for muuuuuch cheaper.

 

Parts needed:
14b
1g J-pipe
2g LICP
10" x 2" pipe (with beads welded at ends)
2g oil feed line (oil filter side)
1g oil feed line (turbo side)
1g or 2g drain pipe
1g or 2g water lines (bending needed)
Rubber fuel injection line
High-temp Copper/Silicone gasket maker

Total cost of install kit: $40


1. Cut the 2g LICP inbetween the two 90* bends
2. use 10" long pipe to raise LICP to the 1g J-pipe
3. cut 2g oil feed line near turbo
4. cut 1g oil feed line near the already cut 2g line
5. connect the two feed lines using fuel injection hose
6. install water lines, bend as needed
7. use gasket maker in place of mani->turbo, turbo->o2 housing, o2 housing->downpipe gaskets.

 

thanks for the info.

next quesiton: would anyone be avaible to give me a hand w/ the install considering i really dont have any idea of what im doing beyond simple bolt ons. considering the turbo is an important part to our car, i just wanna know that it was done right, and i
doubt i'd do it right myself.

also where are those parts avaible?

i hate sounding like a lazy dumbass, but i dont know the car like a lot of you guys do. heh

 

where are you and when do you want to do it?

 

im right across the street from USF campus. car is in tranny shop now, so depends when it gets out and i can go get the turbo. and i would also need to get the parts.

so hoppefully sometime by the end of the week, before the meet. how long would it take to do?