CTR JDM Pistions
Guest
Posts: n/a
CTR pistons in a stock B16A block and head will yeild a 10.8:1 compression ratio. here is an awesome tool to figure out the compression ratios for almost any B series block, head, and piston combo. You can even enter in variables for deck height and head gasket thickness.
http://www.c-speedracing.com/howto/compcalc/compcalc.html
http://www.c-speedracing.com/howto/compcalc/compcalc.html
Thread Starter
B16ACRX
Joined: May 2002
Posts: 0
Likes: 0
Originally posted by "TampaSol"
here is an awesome tool to figure out the compression ratios for almost any B series block, head, and piston combo.
http://www.c-speedracing.com/howto/compcalc/compcalc.html
here is an awesome tool to figure out the compression ratios for almost any B series block, head, and piston combo.
http://www.c-speedracing.com/howto/compcalc/compcalc.html
__________________
WTB:A clean 90-91 civic hatchback. Red or black or white in color. Good exterior. Looking to spend around $2,000.
WTB:A clean 90-91 civic hatchback. Red or black or white in color. Good exterior. Looking to spend around $2,000.
Registered User
Joined: Dec 2001
Posts: 258
Likes: 0
unless your motor is new as shit, your not gunna be able to put pistons in it unless the crank is out, which means COMPLETE REBUILD!!!!!!!
using standard pistons on an older block is gunna have a shitty ass ring gap and piston to wall clearance will not be within specs, or will be at MAXIMUM tolerances. i would suggest a complete rebuild with oversized pistons.
using standard pistons on an older block is gunna have a shitty ass ring gap and piston to wall clearance will not be within specs, or will be at MAXIMUM tolerances. i would suggest a complete rebuild with oversized pistons.
