so check it out. my car revs when i step on gas hard but car wont go anywhere. obviously its slipping. now my master clutch cylinder is like completely gone. would that make my clutch slip or is the clutch going bad?? reason i ask is because when i put my motor together about 3k miles ago my clutch has plenty of meet on it. it doesnt make sense for it to get bad. I dont think my rear main seal is bad because i have no oil dripping for there...

What you guyz think?
Is it time to replace the clutch and while im there, the rear main seal?
Anyone know of any decent place to get a clutch kit from?

MOTOR is gsr.

Any input is appreciated.

 

It could be related with your master. At least you keep this forum alive lol.

 

so u think that the master would not be putting enough pressure and causing it to slip???

 

lol thats really funny tho..... well i know everything is being fixed right so i know exactly what im doing and not taking someones word on it.

 

Oh chris, chris, chris lol...

 

Clutch City Online
Get new booster
get new slave
resurface flywheel
Get Integra to install it
Clutch city has every part you need and sells kits with flywheel also. I have yet to find anyone cheaper

 

i have a fidanza flywheel so that will be resurfaced. and cmon gxer lol. bare wit me here.

so u guyz think its the actuall clutch going bad then??

 

you need to replace any leaking clutch compenents, aka slave or master cylinder and bleed the system before you take your tranny off

 

what will that accomplish? you think that the master cylinder can cause the clutch to slip?

 

Tampa clutch supply sells good clutches for a reasonable price. So it goes into gear without grinding?