Well i just dropped an engine in my car yesterday and finally got it to turn over today. Anyway I drove good for like 4 hrs and then i was driving the car and it suddenly just turns off. The check engine light comes on and my car will not start up. To make a long story short i started hiting the starter and started up again and i drove it home. On the way home the CEL was on the whole time and the rpms where going all over the place but the car was reving any different. I get no codes when the car is off. The check engine light only comes on when i start the car.

 

step one...pull the code
step two...tell us the code

 

well turn you cars auxs on and and then check for the code or turn the car on. then reqad it and tell us.

 

I get no code when the aux is on. When i turn the car on it is just on. no blicks or anything. Just on. Is there a way to get it to give me a code??

 

you need to jump the plug with a wire down by your ecu for the light to flash

 

there is a green plug on the passenger side next to the ecu that has 2 holes you have to jump it (make a u out off a paper clip and have it in both holes) then you can run the aux and the code will blink.

 

thanks for the help. It blinks twice slowly and then has a break and blinks 5 more times. they are all the same speed except for the last blink on the 5 spread. It ends really quick compared to the rest.I looked up the code and didnt see anything. Im not really sure how to read it but i thought it was 25.

 

it could be showing you 2 codes.
2 and 5
i dont know though

 

Thanks!