ok i swaped my crx to mpfi and now i wanna go vtec single cam and i bought a pr3 and when i start my car the ecu gives one code forever red the red light comes on and stays on ...the ecu starts my car after lik 20 turn overs im lost at whats going on and car is in limb mode
help!!!

 

to my understanding solid mil is code zero which indicates a faulty ecu...goodluck

 

check wiring also for faults or maybe faulty ecu plug pins could be alot of things

 

not the wiring cuz i still got my pm6 and when i plug it in it works fine

 

thts what i was thinking but it dosent have any burnt spots but the dude told me it was chipped so cud tht b the problem

 

sounds like ecu is the problem.

 

bad chip possibly ive had it happen to me before replace the chip and try again

 

okk i will

 

If It Is Socketed You Can Take Out The Chip And Cut I Think Its Jumper 1 (j1) On The Board Next To The Socket And It Should Run Off Stock Program I Know It Works On 0bd1 Like That I Believe 0 Is The Same Not Too Sure Pm Mtber And Ask Him

 

idk how to do tht but ill try