ARP connecting rod bolts?
engine building &best
Joined: May 2003
Posts: 11,971
Likes: 0
you will be fine the rod bolts are all cut the same way so this does not happen.i myself install them with a press and a lil solid plastic tube i made...when installing the arp bolts make sure the tilt cut side is on the outside you will be fine
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
90% grind 10% sleep
Joined: Nov 2002
Posts: 6,963
Likes: 0
have a machine shop install the bolts, its cheap and you wont have problems.
I have a set brand new but its only for 3 rod sets,you could call arp with the part number on the package and see how much 2 bolts and nuts would be. LMK if you want them.
I have a set brand new but its only for 3 rod sets,you could call arp with the part number on the package and see how much 2 bolts and nuts would be. LMK if you want them.
__________________
727-510-6301
Honda Valve Adjustments 50$
I buy and/or Fix Broken Honda transmissions.
I TUNE KPRO AND S300
I DO NOT WORK FOR FREE
E-Z OUT BOLT AND STUD EXTRACTOR: A tool ten times harder than any known drill bit that snaps neatly off in bolt holes thereby ending any possible future use.
727-510-6301
Honda Valve Adjustments 50$
I buy and/or Fix Broken Honda transmissions.
I TUNE KPRO AND S300
I DO NOT WORK FOR FREE
E-Z OUT BOLT AND STUD EXTRACTOR: A tool ten times harder than any known drill bit that snaps neatly off in bolt holes thereby ending any possible future use.
popeye built!
Joined: May 2005
Posts: 3,114
Likes: 0
This probably isnt the right way, but on my last motor i had stock ls rods on wiseco pistons and i just hammered out the old rod bolts and pressed in the new arp's by hand and then when i torqued them down, the bolts set in all the way and i never had a problem with the motor(400+whp)
__________________
Can't spell strength without tren
AAS...It's whats for dinner
Can't spell strength without tren
AAS...It's whats for dinner
Thread Starter
Great White Hope
Joined: Feb 2008
Posts: 1,081
Likes: 0
No thanks on the bolts, I just bought some a couple of hours ago.
And thanks for all the help, everyone. Rep has been given to those who I can give it to!
And thanks for all the help, everyone. Rep has been given to those who I can give it to!
__________________
"The richest man is not he who has the most, but he who needs the least."
"The richest man is not he who has the most, but he who needs the least."
TR "Old Skool DA" Member #28
