Very simple, I help change the tranny on my friends 92, It's only like a 3-4hr job. Pm me I can pretty much give you a full detailed instructional lol

 

Awesome thanks guys i surley shot ya felas some pm's.The car is in the garage and on jackstands battery has been out and itook the axles out about an hour ago..I have taken the dist. off and had to cut the wires..Plugs are a little dryrotted it looks like youd have to take it off to get at a few of those 17mm bolts.Now the next thing There are bits of the wiring harness around the tranny that seem to be,They haved to be removed for the tranny to slide out.?

 

its a bitch lifting the tranny back onto the splines.

 

be sure to inspect all of the dowels before putting it in there. to make sure that you dont have dowels in the block and the trans and to make sure theyre not fucked up.

 

Ok well slow moving BUT Shes about ready to come out I have 2 mounts off and most of the bellhousing bolts off and what is holding me up is the main shift rod,Not the extened.I need that punch to get that pin out....
anyone wanna give me a hand? I also gotta do just a tiny bit of wiring

 

it being your first time just remove the shift knob out your car jack the car up alil more and undo the 2 12mm bolts holding up the whole shift just remove the whole thing with the transmission and take it off when you get the whole thing out

 

yup. do that...then you can turn the trans over and pound that bitch out real quick....i used a 1/2" battery terminal bolt from advance.