So yeah,

just got my ASR endlinks in. Took sway bar off to try and install them but they did not seem to fit on the sway bar side. they appeared to fit fine on the LCA i have, jsut won't fit where the old swaybar bushing was (yes I took 'em off as it seemed that the ASR endlinks ought ot replace those).

Does anyone have any experience with this specific setup and could pipe in? Do i need some kind of adaptors? (I saw that ASR website mentionned adaptors but had no pic associated with it).

Current setup is SKunk2 LCA, ITR (22mm) OEM sway bar, ASR subframe. ASR endlinks (OEM endlinks's bushings are shot! I don't know where to find new ones)


thanks in advance.
peace

 

You could always get the OE endlink bushings from honda. But I would call ASR up and see what they tell you. Maybe they sent you the wrong ones by mistake?

 

I just send an email to ASR. I went through jhpusa so I may have to do the whole "restocking fees" bullshit unless ASR is real nice and is ok to reimburse me if it's the wrong ones... but we'll see what they respond to my email.

for the OEM bushings, I just don't know which ones I need (and since i spent $80 on ASR endlinks, I don't wanna lose that money! times are hard these days!!)... i mean what part number. Actually I would probably have to call teg dealership since the itr sway is well, Integra. so should need sway bar end bushings and endlink bushings... found this reference on some website on the net (52319-ST7-Z00-Enlink bushings). not sure if that's the correct one and still missing the other bushing, the one for the where the endlink connects to the swaybar...

Guess i'll have to be patient

 

call berto if you decide to go that route

 

thx T. I will, I'm jsut trying not to lose the money I invested! times r hard!

 

I hear that. I never thought about it but, I could have ran to the shop and pulled the end links off my sway bar for you to use till we got the situation figured out..