Clutch pedal to the floor
No really,....it is
Joined: May 2006
Posts: 2,984
Likes: 0
yes its most likely just grease for the rod. a very common honda problem are the salve cylinders. they range from 15 to 30 bucks at auto zone. thats what i would check first. very easy to see if its leaking or not. but there is a chance it could be clutch master cylinder too. check out both. all the problems like you are describing ended up being slave cylinders. check it out and let us know what you find.
Rockin' 4 more Cylinders
Joined: Apr 2004
Posts: 11,897
Likes: 0
yes its most likely just grease for the rod. a very common honda problem are the salve cylinders. they range from 15 to 30 bucks at auto zone. thats what i would check first. very easy to see if its leaking or not. but there is a chance it could be clutch master cylinder too. check out both. all the problems like you are describing ended up being slave cylinders. check it out and let us know what you find.
salve cylinder FTW
__________________
RIP Kevin Gonzales AKA Slo_Si 9/06
RIP Robert Kolp aka 00ek 4/07
RIP Pablo Garcia aka FatHead 9/07
_Jake D
RIP Kevin Gonzales AKA Slo_Si 9/06
RIP Robert Kolp aka 00ek 4/07
RIP Pablo Garcia aka FatHead 9/07
_Jake D
No really,....it is
Joined: May 2006
Posts: 2,984
Likes: 0
yeah you can replace the "salve" cylinder but its a bitch and real expensive. like 400 bucks. id just replace the slave cylinder and be done.
No really,....it is
Joined: May 2006
Posts: 2,984
Likes: 0
if you read the post above it, it was a joke. i was referring to the "salve" cylinder that jake d pointed out i miss spelled it. Read a little bit, you will understand.
Thread Starter
Registered User
Joined: May 2006
Posts: 464
Likes: 0
ok guys, it was acting up bad last night and when i drove home it like exploded on my driveway. I replace the slave which was like 15-20 bucks and its a new car again. Ty for all the help take care
__________________
All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. (1925 IBM Maintenence Manual)
All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. (1925 IBM Maintenence Manual)
No really,....it is
Joined: May 2006
Posts: 2,984
Likes: 0
Thread Starter
Registered User
Joined: May 2006
Posts: 464
Likes: 0
yeah i know, lol im lazy
__________________
All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. (1925 IBM Maintenence Manual)
All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. (1925 IBM Maintenence Manual)
