it was no earlier then November..so it hasnt been four months...and i dont care what you think..i have witnesses that know the block has been in the shed...i also...have my shop(2nrwerks) that saw the block. They are the only ones i trust to build my shit and well they never touched a bolt on it..they noticed the pistons instantly and i took it home..believe what you think...i know from experience it only takes a few miles to hurt a motor..i put 150 on my first lsvtec when it spun a rod bearing...bad build...lost 1500 on it...also..u told me 150 miles to 200 miles where on the block..now its down to 75...u also told me u dont believe in breakin them in..u dog them as soon as they are built..u told me u scared john vega with ur single cam when u were street tuning it.....like i said..the court will figure it all out..i have more then enough proof and witnesses...and your just going to hurt yourself...im asking nicely and i repeat NICELY to get the laptop back..and call it even...but NO..u wont..so thats fine..ill do whats necessary..i havent said one mean word to you as a threat nor plan to..im being as nice as possible after gettiin screwed over on a 1475 dollar block....

 

also integra plz do..i hope all of his friends go..i know what was done..im NOT retarded...this block HAS NEVER BEEN USED AFTER MIKE...so there is NO excuse....say what u want..i Have proof.....like i mentioned..i dont know who was at ur house with you when i bought it..BUT...inbetween the sleeves and actual block..there was like corrosion from the water from sitting...ITS STILL THERE...if i used it..that stuff would of been long gone by now..but it doesnt matter..like i mentioned I HAVE PROOF...believe what u want..after the court ill post how it went..

 

also the swirl marks are still there..thats not where its chipped..its very hard to see but its chipped on the intake valve releases...my builder(rick at 2nrwerks) said it was from heat..either to much timing or not enough fuel..and big mike admitted to have a chip from vega that was notmade for fuel throttle...and from what he told me he dogs all his builds as soon as there done...he also told me as soon as i get this done...to dyno tune it that day..it will hold up..hmm wonder why he said that?...he also said put like 18lbs on it?...why? so it can blow up on me...and ur free and clear..to bad you were caught before hand huh?...

 

This has turned into he said she said. I don't know who did what, nor do I really care. But, this has gone on and done ALL the good that it could do on this site. You got your response. So this is over.
-Keith