Hey everone well my tranny has been acting up for the last couple of weeks, at first the car wouldnt want to go into any gear and i had to force the shift stick into the gears and when ever i would come to a complete stop and start in 1st gear the car would start shaking really bad, well yesterday i put in a brand new clutch, pressure plate, and flywheel. The car goes into the gears real nice and grips really nice but it still shakes whenever im in a complete stop and start from 1st gear (also does it in reverse) it does it as soon as i start taking my foot off the clutch and thats the only time it does it after that it picks up fine even when i switch gears its fine, my old clutch was real messed up and thats what prevented it from going into the gears but i still have this one problem which still shakes alot and i would like to see if this had ever happened to anyone or if anyone knows if i would have to rebuilt my tranny or anything like that, all the help is appreciated, thanks. (its a b16 hydro tranny)

 

I was gonna say flywheel might be glazed over and have hotspots but you said you have gotten a brand new one.

 

is it a hydro or cable clutch?

my hydro master cylinder is leaking and oops i didn't fill back up the fluid and the brake fluid was at the garage for it so i jammed it in gear to start it and kept my foot on the gas and brake autox style while at lights so it wouldn't die. yea behind a cop even, like no sir i am not reving my engine at you i just need to keep the car from dying, my garage is right over there.

i really need to fix that sooner or later but one problem at a time

 

yeah its a brand new exedy flywheel (i knew the clutch was out but i ordered the flywheel thinking that was causing the shaking) but i was wrong, but i did need the clutch though which i did order as well and it is a hydro tranny

 

With some cars, motor/trans mounts and rubber shift bushings get worn.
So now the motor is in a different spot than the shifter expects it to be,
and that affects shifting.

Worn mounts will cause vibrations at traffic lights and when stopped.

When were yours replaced/rebuilt? I have had good luck stiffening
and/or rebuilding motor/trans mounts. Did that ever make a difference!

If it turns out that your mounts are cracked, etc., pm me.-Bob

 

How about checking the obvious, Did you check your oil level in your tranny? I knew somebody that had almost the same prob, he put genuine honda oil in his tranny , smoothed it right out.

 

well thanks everyonw for the help, i took out the motor today and the rear motor mount was worn so i replaced with a new one, the car doesnt shake as much, but still does. Someone told me that its probably my pressure plate and i would need to get it adjusted, but idk i will see what happens. - Da1andonlyjinx did your friend use transmission honda genuine oil or just regular motor oil to put it in his tranny let me know thanks.