ok I have searched already but find conflicting info. I have a 93 dx hatch that I am putting a sirII b16 into. what shift linkage do I need? and which axles?

some say that the 00si and 94-01 integra linkage is the same and some say it's different. which is it? the axles if I have it right are from the 94-01 or 99-00 si. correct me if I have it wrong thanks.

 

You should be able to use LS axles and im positive you can use a EG SIR linkage but im not shure of the avalibility of one :\ GL

 

I used an integr a typr R linkage, not cause im a baller!!! but cause i got it from a wrecked one, and i have an EG as well, yes the JDM one will fit from an siRII but they usually dont come with the swap. i know that the only unique linkage is a Del Sol, it will only fit a del sol, and no other swap. the 99-00 si's, work in the EK swaps, and i have never used one in an EG.

the axles i use are 94-00 integra gsR, NON abs


hope this helps, my car has run flawless for almost 3 years on that info

 

In an EG you can use the following linkage:

-94-01 teg linkage
-99-00 si linkage
-93+ del sol vtec linkage (cut and weld) not recommended unless necessary, done it once.

I would also imagine 90-93 teg linkage would work with a cut and weld but I've never done it nor really recommend it.

Another quick note on linkage on a del sol is that if you are actually swapping into a del sol the 93+ vtec linkage is the only one to use and modding teg linkage is not easy for that swap.