i found a brand new b16 distributor obd0 and if i put it on my b16 head for my lsvtec wuts a good ecu to run a p28 chipped or pr3 ecu would i have to upgrade with a harness? help me out with ur suggestions.....thnx

 

YOU CAN NOT RUN THE OBD1/2 DISTRIBUTOR WITH THE OBD0 ECU.

:End Emphasizing:

 

with that dizzy you must run an obd0 ecu. A pr3 or a pw0 will work great. there is even "turboedit" to tune these obd0 ecu's. turbo edit is a shareware(free) rom editor for obd0 ecu's. with this program you can tune your timing/fuel curves, set your vtec crossover point, and the rev limit.

 

well wut is a good dizzy to use for a chipped p28?? or were u find the turboedit at?

 

any Berseries OBD1/2 distributor will work with the Ls vtec setup you are trying to make. You can find them all over Honda-Tech or look up www.distributorking.com as well. You can find all the free ware stuff on PGMFI.org

Jason