Brake problem...
Tattoo the Planet
Thread Starter
Join Date: Jul 2003
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Brake problem...
I just did the brakes of my civic dx and I'm getting some interesting results I've not run into before. Initially they go almost to the floor but do stop the car. I pump them up and they do not fade at all. I'm figuring no air in the lines but I'm not sure. Any help is appreciated. By the way I replaced the back brakes.
__________________
JPsacred
JPsacred
engine building &best
Join Date: May 2003
Posts: 11,971
Likes: 0
Received 0 Likes
on
0 Posts
sounds like you did not bleed them or you have a crack in a line or if you did bleed did you tighten the boltback
__________________
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
i love AUTOZONE
MY CAR iS PROTECTED BY ZOOMBAK GPS LOCATOR IS YOURS?
175+served in engines built from minime to gsr/lsvtec,b16 b20vtec,d15 k24 powerhouses or just rebuilds.life is good
i like when people don't take my advice.cause then i make more money when u need it rebuild the right way!
how many speed holes do i need in my bumper,b4 i can run 15's?
If you open the line then you need to bleed the brakes, but if you just changed the pads, when you push the piston in then you only need to pump up the brakes up and the it will be fine.
like crix said you need to bench bleed the master
__________________
"STRICKLY MT" Shop open for business
Tuning available for S300 and Kpro
727-510-6301 Tristan
11.99@116 All Motor K24 Civic Eg6 on Drag Radials
MattBuilt
"STRICKLY MT" Shop open for business
Tuning available for S300 and Kpro
727-510-6301 Tristan
11.99@116 All Motor K24 Civic Eg6 on Drag Radials
MattBuilt