So i finnaly got my car back together after putin all new gaskets in it, i filled it up with some water to see if all my seals were tight, i have two puddles of water under my car in the same spot arond where the fire wall is. I think it may be leakin underneath where the exaust transfer whatever thing that connects to the back of the heads? But what could be leakin? Thanks for the help

 

did you reconnect you heater hoses?

 

or your heatercore is leaking out the drain hole

 

Sounds like you may not have gotten the head seated properly. I once had a friend who had a leak at the firewall after he redid his heads. Turned out that when he pulled the heads, one of the alignment dowels stuck in the head and one stuck in the block. When he put it back together, he put another dowel in the empty hole in the block. Put the head back on and torqued it down not realizing he had 2 dowels in one corner of the head. That leaves a bit of a crack at the corner.

True story. Check and see if the head is on straight.

 

+1 or the intake not sealed on the ends properly.

 

Does this car have A/C? If so, it could be the A/C condensation. Just sayin'.

 

I was thinkin the same thing Tim... Sometimes its not always a problem, and more of, the car doing its thing.

 

Could also be condensation from the exhaust.

 

This reminds of a time when someone was gonna tear apart their engine because of overheating, when low and behold the thermostat was bad... Remember that guy Tim? Lol jfwy man.

 

No....Who was it again? Hmmm.....I heard he was a bad ass too....Of course, the guys wife said he was a whore too....Not HER, HIM!