OK I feel this is a stupid question but what ever. I have an SFI flexplate on my car and its always rubbed the block plate. (plate in between motor and tranny) I have the tranny out and the block plate is all fugged up. Do i get a new or or just say fuck it and don't put one on at all. The last time i did that i had a bunch of starter problems. So through some ideas out there.

 

if you have an sfi bell you probably don't need a block plate, just check for play in the converter before you bolt it back up

i cut the whole middle out of mine before i got the sfi bell, it only lines up the starter and give you an extra black lady cunt hair for converter in and out.

 

can you smack it flat w/ a hammer?

 

AOD Nugga, Remember its a street car with overdrive..... and 4:30 gears..... Someones retarted

 

its way to gone i may just cut the middle out like steve said I like that idea best so far.

 

not me, you can put an sfi bell on an aod, you just cut the front off, big money

 

trim that shit with tin snips s0n

 

if you don't need the extra clearance for the converter depth....rock with out it.

 

Think i'm just going to cut it. Now that i think about it, my starter is already close to the header and missing that plate will push the starter that much closer to it so.... Either that or my "FORD" tool will have to come out of hiding.

 

im pretty sure you need that beast in there otherwise your starter is definatly not gonna line up. i would agree to cut the middle of that bitch out and see if that works.