Heres a mod list. with everything listed below how much hp do you think you shuold get out of a 331 witht the following mod list?

Factory block with a main girdle Bored to 331
4340 steel crank
Eagle H beam rod
JE pistons
Tfs twisted wedge heads
Stage 3-port work
Victor 5.0 intake manifold
Stage 3-port work
ford racing x303 cam (looking for better cam)
Crane gold 1.6 rocker arms
Canton oil pan
24lbs injectors
75mm tb
powdercoated valve covers
Aeromotive fuel pressure regulator
3.73 gears
BBK longtube headers
BBK H-pipe with 2 1/2in exhaust wiht flowmaster 1 chambers (hatem)
CnL mass air flow sensor and inlet tube
McCloud Clutch

 

give me some comments of what you guys think that it would do on the dyno without a tune

 

would need to know things like compression, etc. probably mid 300s or so. higher compression will mean more power.

 

anything over 1hp per cube inch is good

 

compression is 10 5 1

 

how does a stock 5.0 make to the wheel?

 

Well if you have the Adam Glidden signature series than at least 600 !

 

these very limited edition blocks have the signature of Adam Glidden as show here.

 

200 maybe a hair less stock

 

dude dont skimp on a alphabet soup cam